Mesh load on part of a mesh

Hi Karamba users,

I have a question regarding mesh loads. I want to put a load on a certain part of a mesh, see the picture below:

I now make a seperate mesh and put the load on that mesh. But the two meshes have different triangulation so the load is distributed weirdly. Does anyone else have experience with this?

Greetings,

Raphaël

Replies to This Discussion

Permalink Reply by RaphaelKilsdonk on February 21, 2018 at 12:50am

It also goes over the edges of the specified surface/mesh:

Permalink Reply by RaphaelKilsdonk on February 21, 2018 at 2:30am

Another example:

Permalink Reply by nicebikemate on February 21, 2018 at 3:10am

I wouldn't have thought you'd be able to do it easily by re-meshing. I would approach it by trying to isolate the areas vertices you want load, perhaps by a separate surface and then points closest to it or something?

Permalink Reply by RaphaelKilsdonk on February 21, 2018 at 3:44am

I found a solution by deconstructing the mesh and adding the vertices to the intersection points of the base mesh.

Permalink Reply by nicebikemate on February 21, 2018 at 3:46am

Good one, and thanks for posting the solution :)

RSS