Mesh Closest Point - Strange results?

Replies to This Discussion

Permalink Reply by Hannes Löschke on April 4, 2013 at 4:20am

All the MeshCPs are on the mesh. for your points on the right, the original points were above the mesh, on the left, they were below. Rotate the view, so you are looking at the edge if the mesh and you will see...

Permalink Reply by Wendy on April 4, 2013 at 9:47am

Hannes,

Thanks for your reply. I had been rotating and still not seeing what I would expect. Here's one example. I added a MeshRay component this time, confirming that the original group of points are indeed below the mesh. Is this just a display anomaly?

Permalink Reply by Hannes Löschke on April 4, 2013 at 3:07pm

Okay, this looks like a display issue on your side. I don't get any of this. CPs are on the mesh as expected.

What's your Rhino and GH version? Are you using accelerated graphics?

Permalink Reply by Hannes Löschke on April 4, 2013 at 3:13pm

oookkay.. just replicated that issue by deactivating HW accelrated modes.

Permalink Reply by Wendy on April 4, 2013 at 6:15pm

Thanks for figuring that out! I was beginning to doubt my sanity.

Rhino Version 5 SR2 (5.2.30328.21415, 03/28/2013)

Grasshopper: 0.9.0014

I'm already using Hardware Accelerated mode. Do you see anything else?