Grasshopper

algorithmic modeling for Rhino

Mesh and point visible in Ladybug

Hey guys I have just started with ladybug and fount out that the red lines of the mesh as well as the dot appear in the display making it very difficult to visualize. How can I prevent that from happening, I am afraid I have accidentally changed that.

I will add a pic of how it looks so you can have a better idea. 

Views: 854

Replies to This Discussion

Permalink Reply by David Rutten on October 18, 2015 at 12:45pm

To hide mesh edges, press Ctrl+M (also available via the Grasshopper Display menu). If you don't want to see the points, you'll have to switch the preview off for whatever component is displaying them.

Permalink Reply by Luis E. Lopez on October 18, 2015 at 12:50pm

Thanks, may have typed accidentally. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service