Grasshopper

algorithmic modeling for Rhino

Merging close point together

Hi,

I´m currently working on a triangular gridshell dome. 

From here it looks okay, but when i zoom in, i can see there are multiple points at each node of the gridshell. How do i merge them to be only one point and then connect them again as shown above ?

Regards

Frede

Views: 3647

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on January 14, 2015 at 7:14am

There is a Component Cull Duplicates where you can set a Tolerance for their proximity

Permalink Reply by Frede ranjit on January 14, 2015 at 8:14am

Already done that, but it doesn´t help.

Permalink Reply by Danny Boyes on January 14, 2015 at 8:33am

Use it in conjunction with Find Similar Member

Permalink Reply by Frede ranjit on January 14, 2015 at 8:42am

Super, thank you !

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service