Merge Data

Replies to This Discussion

Permalink Reply by David Rutten on June 11, 2012 at 3:32am

Hi Jyoti,

you'll need to change the data-paths to match up as well. Flattening the inputs of a Merge component will do this, but it may destroy too much information depending on your specific case.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by JYOTI SHARMA on June 11, 2012 at 3:44am

Hi David,

Thanks a lot for your reply... Flattening did work ...however I was thinking if there is any way to make the path similiar without adding any additional steps to make the paths equal.

Permalink Reply by Danny Boyes on June 11, 2012 at 3:35am

Unfortunately you chopped of the most interesting part of you image, the actually data path structure displayed in the panel.

It would help a lot if you could upload your definition with any referenced geometry so I can work with the structures as you see them as there are a number of methods to sort this but its not a one size fits all?

Permalink Reply by JYOTI SHARMA on June 11, 2012 at 3:46am

Hi Danny I have not referenced any geometry from Rhino. However Please find attached the grasshopper defination. Thanks a lot for ur interest.

Attachments:

• transform 2.gh, 7 KB

Permalink Reply by lucas cañada on June 11, 2012 at 3:40pm

Hi JYOTI; try entwine. hope helps ;)

Attachments:

• transform2_1.gh, 8 KB