Grasshopper

algorithmic modeling for Rhino

Maping a surface with a perforated plane

Hi 

I have a complex surface and I want to distribute over it a perforated plane that I've created.

So far I have divided the surface in order to match the corners of the plane with the new points on the surface (image and definition atached)

I'm not really sure if this is even the right way to go about this, but I'm kind of stuck, and it might be more complicated than I think.

Any ideas?

Thanks

Views: 707

Attachments:

Replies to This Discussion

Permalink Reply by Florian Frank on March 12, 2013 at 2:29pm

Hi Gustavo,

is this what you tried to do?

i deleted some parts, that were not needed, but in general i think you had a good approach.

Hope this helps. Cheers,

FF

P.S: Sorry for my ugly curve ;-)

Attachments:
Permalink Reply by Gustavo Brod on March 12, 2013 at 4:18pm

Hi Florian,

that was it, the pull curve its not working properly thou.

I've tried flattening it didn't work, however do you think I can use the curves resulting from the MapSurf to create a surfice with the curve holes in it? (image: curve holes on the left)

Thanks for the help

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service