map to surface problem

Replies to This Discussion

Permalink Reply by phillip on March 17, 2014 at 8:32am

It will be more sufficient to build sub-surfaces individually, rather than splitting one large surface.

Could be any method to pick the right points. E.g. like this:

Attachments:

• parrallelogramm.gh, 12 KB

Permalink Reply by Kaz on March 17, 2014 at 11:39am

Thank you dear Philip , I appreciate your help 

I applied your definition grid on my surface using evaluate surface approch ,but the results was nothing but a mess , I did the following : 

1- surface grid using surface from points component , (it works but it gives one error about u amount..)

2-divided the grid curves using divide curve component 

3- surface closest point  , its points are connected to step 2 , and its surface are connected to step 1

4- evaluate surface m the surface input is connected to target surface , and the uv point are connected to its sister at step 3 

5- poly line which its vertics input is connected to the output points of evaluate surface 

unfortunately the results are not as excpected , 

i appreciate your help 

thank you

Attachments:

• parralelogram 2.gh, 17 KB