Grasshopper

algorithmic modeling for Rhino

map lines onto surface?

Hi there

I was just wondering, is it possible to morph/add a grid of lines I have made within Grasshopper onto a surface. I have a grid of lines in 2d that I have made between to lines. That I would like to map onto a surface! How can I do that?

Thanks

Views: 291

Replies to This Discussion

Permalink Reply by Dirk Anderson on June 23, 2009 at 9:44am
Do you mean... ApplyCrv, Project or Pull?
Permalink Reply by mombassa on June 23, 2009 at 10:18am
Hi Dirk

Thanks for your reply! I think pull might be best for the thing I am trying to do! What I would like to do is to apply this pattern I have made onto the surface of the structure! It would be really nice it I could continue to change the pattern even after it has been applied to the surface! Do you thing pull is the best option for this? And can you even do pull in Grasshopper?

Permalink Reply by mombassa on June 23, 2009 at 11:11am
Actually, I think the ApplyCrv might be better! Is that possible to do in Grasshopper?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service