map hexgrid on a dodecahedron

hi guys,

I found a dodecahedron-definition on the internet, and now I have tried to map a hexgrid on it, but it look quite strange :-/

if I use my "map-definition" on a sphere, it works. I think the problems is, that the dodecahedron is not one surface, it contains more than one surface.

how can I handle this?

thanks

.mh

Attachments:

dodecahedron.ghx, 538 KB

Replies to This Discussion

Permalink Reply by Marios Tsiliakos on November 1, 2011 at 10:20am

Maybe something like this...

Attachments:

12edronHoneycomb.ghx, 812 KB

Permalink Reply by Michael Herbig on November 1, 2011 at 12:50pm

hi,

that looks better, but at the top and bottom the grid concentrates to one point, is it possible to make it more uniform?

my goal is something like that:

http://www.code-collective.org/post/3459929843/geodesic-paper-insta...

Permalink Reply by Marios Tsiliakos on November 1, 2011 at 2:19pm

Hi Michael,

take a look at this post.. it uses geodesic instead of hexgrid... if you have a "normal" distribution of points you can get an "almost" hexagonal tiling, which is not concentrated on specific points. just replace that part of the code in my def...

Permalink Reply by Michael Herbig on November 2, 2011 at 1:06am

thanks for trying to help me ;)

I looked at the definitions, but that really hard to understand, what could i use from it and what not.

The problem for me is, it is based on random. I try to but the random-definitions out, but that does not really work ...

I will go one to understand the definitions. I hope you have some further advice for me :)

thanks

Permalink Reply by Marios Tsiliakos on November 2, 2011 at 8:58am

Hi,

Sorry but I have been busy at work. I used kangaroo and circle packing to get a more normal distribution of the cells. The cells have 6 vertices but they are not normal hexagons... I believe the answer lies somewhere there. you have to run a few tests..

Regards M.

Attachments:

12edronHoneycomb_CP.ghx, 909 KB

Permalink Reply by Jon Mirtschin on November 4, 2011 at 11:43pm

It's a nice idea and expression. Here's my quick attempt at it with StructDrawRhino (probably a good idea to update to latest, as I fixed a tolerance issue with the polyhedra, http://www.geometrygym.com/downloads)