Lyrebird NO families in LBOut

Replies to This Discussion

Permalink Reply by owe on March 5, 2014 at 4:31am

Ok, i got the families, but when I try to export a wall from a curve generated in Grasshopper i get this error message in Revit: "Writing of Entities of this Schema is not allowed to the current add-in"

Permalink Reply by lmnts on March 5, 2014 at 9:21am

For some reason it's seeing a disconnect with the Vendor ID.  If you look at the addin file, does the vendor ID show 'LMNA'?  

Also does it give you any similar errors with the other creation methods (origin point or adaptive points)?

Permalink Reply by Mel King on February 6, 2017 at 3:05am

Hello Lmnt's ,

I am getting a similar error: Writing of Entities of this Schema is not allowed to the current add-in"

Can you advise where this xml file is stored and what program to open it in to check the vendor id and edit if necessary? thanks 

Permalink Reply by lmnts on March 5, 2014 at 9:10am

Just in case someone else needs to know...

Make sure you have the Lyrebird Server toggled to the On position in Revit.  By default it's off because it can be a resource hog if left on all the time.

Permalink Reply by Matt Schmid on March 11, 2015 at 4:53pm

Hi There, 

I'm also getting this error, but the Lyrebird server is definitely on. Any thoughts?

Permalink Reply by Djmonster on April 15, 2015 at 10:36am

Sorry to bother, but can u please help me with this problem.

I did turn on the Lyrebird Server On in Revit and set the Revit 2015 version inside Rhino?

But I keep on getting this error. The data could be transferred to Revit but it has no Family or Type so the Revit can not generate the model inside.

I didnt install Revit on C: drive. is it because of that the Lyrebird could not find the Family and Type folder?

 

Thanks