Grasshopper

algorithmic modeling for Rhino

Lunchbox Diagrid Structure

I'm trying to generate a diagrid on each of four surfaces using Lunchbox. However, when I set the surfaces in grasshopper and plug them into the Lunchbox diagrid component, Lunchbox generate a diagrid that conforms to a bounding box of the surface, rather than to the irregular sides of the surface itself. 

Any ideas as to why this is?

Thanks. 

Views: 2288

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on January 26, 2015 at 3:44pm

hello

lunchbox works with untrimmed surfaces. so what you are getting is the diagrid in the untrimmed version of your trimmed surfaces.

you can trim the diagrid with the trimmed surfaces naked edge or try this thread

cheers

alex

Permalink Reply by rmf on January 26, 2015 at 6:34pm

Thanks, Alex - the naked edge trim worked well.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service