Grasshopper

algorithmic modeling for Rhino

LOOPED BRIDGE HELP NEEDED!

Hi guys!

I am trying to design a bridge similar to this, but I can't seem to make the loop in the center, how should I go about it?

THANKS!

Views: 341

Replies to This Discussion

Permalink Reply by Jacob Peel on October 17, 2016 at 7:57pm

I vote for using the Ruled Surface component

Permalink Reply by Phillipe on October 17, 2016 at 8:05pm
Okay, I'm new to this, how do I use that?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service