Lofting two collections of rectangles

Replies to This Discussion

Permalink Reply by Jonathan Nelson on February 3, 2015 at 4:07am

Kind of hard to see in the pic since it's showing mostly planes, but I assume you want to do this:

input each rectangle wire into a single Merge component, grafting each input and then pass into a loft.

you don't have to use the merge but i usually find it helpful as far as clarity goes

Permalink Reply by Guillem Haro on February 3, 2015 at 4:34am

Thanks a lot Jonathan.

It's was I was looking for, yes.

Not exactly, though.

Merge generated the following list 0,1,...,n, 0',1',...,n'

Whereas I'm looking to merge the list in the following order: 0,0',1,1',...,n,n'.

Any ideas?

Still, thanks a lot for the help!