Grasshopper

algorithmic modeling for Rhino

Lofting two 3D curves

Hi There,

I can't create a surface between these two curves easily, either on Rhino or Grasshopper. I would have to divide it manually in rhino and then loft / sweep2 them part by part.

Yet, I have many of these pairs so it would be great if it could be done on grasshopper!

Thank you,

Levent

Views: 354

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on October 30, 2017 at 7:29am

Attachments:
Permalink Reply by Joseph Oster on October 30, 2017 at 7:40am

Wait, how did I miss this?!

Attachments:
Permalink Reply by Levent Ozruh on November 11, 2017 at 9:21am

Hi Joseph,

Sorry for the late response, thank you very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service