Grasshopper

algorithmic modeling for Rhino

Lofting Trouble HELP!!!

Does anyone have any idea why these two merged geometries won't loft? I have a panel on surface for the base geometry and then I created polygons from the centroids of the surface and move them with attractor points. There is no error message but when I click the loft, nothing shows.

Please Help!

Views: 244

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on October 4, 2016 at 9:11am

just saw there are more than 2 curves for each panel. without a definition its hard to tell.

Permalink Reply by Jamel Williams on October 4, 2016 at 9:20am

There is one curve per panel based on the photograph. I am very new to this so i could be wrong.

Attachments:
Permalink Reply by ng5 Alex on October 4, 2016 at 9:22am

oh ok. then if these pairs are per branch (list) organized you can try boundary component.

Permalink Reply by Jamel Williams on October 4, 2016 at 10:00am

Im sorry, can you elaborate on that?

Permalink Reply by ng5 Alex on October 4, 2016 at 10:05am

without a definition. no.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service