Grasshopper

algorithmic modeling for Rhino

Lofting point to curve

I was trying to loft between a point and a curve in GH but it doesn't seem to work, however it can be done in Rhino. 

In GH I merged a point and a curve in one list and used this as the input for the loft curves. it doesn't seem to like this



Is there a way of lofting between a point and a curve in GH. 

Views: 401

Attachments:

Replies to This Discussion

Permalink Reply by Jerrimo on November 13, 2010 at 4:22am
you can use the line component to create a line between two points. The loft component only works with lines and curves.
Permalink Reply by Alexander on November 13, 2010 at 9:22pm
if you convert a line with zero length to a curve,you just get a invalid curve...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service