Grasshopper

algorithmic modeling for Rhino

lofting multiple curve sets

just starting out with GH and i have a question about lofting multiple curve sets. i have populated a surface with a grid of circles, and then offset each circle. i would like to then loft each pair of curves, but i can't figure out how to separate them into pairs since 'loft' just takes a list, as opposed to 'curve a' , 'curve b', and so on.
any advice would be appreciated!
matt

Views: 24989

Replies to This Discussion

Permalink Reply by Danny Boyes on December 19, 2011 at 3:17pm

The Clue's in the error message

Try going back to [Join Curves] and using [Shift Paths] on the output.

Make sure you select Align Curves in the Loft Options

Permalink Reply by Ram Joshi on December 20, 2015 at 10:01pm

HI Matt,

Are the lofted circles still a part of your base surface or they have been separated?

Ram

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service