Grasshopper

algorithmic modeling for Rhino

Lofting large lists

I'm having trouble lofting two sets of curves. 

Both lists are the same length (120 curves). 

However, when I simply plug them into a loft command the order seems to be rearranged. 

Only works when I use the list item command and loft them independently. 

I was hopping there was a better way as 120 lofts take some time. 

Views: 609

Attachments:

Replies to This Discussion

Permalink Reply by David Lister on May 14, 2012 at 11:45pm

Just pass each of the flattened lists from the wbFacePolys to a graft component before lofting and you're sorted. 

- Dave

Permalink Reply by George Faber on May 15, 2012 at 8:53am

Thanks, David

Permalink Reply by Rickey Crum on May 15, 2012 at 8:06am

You might have to "flip matrix" as well.  I could be wrong, but it looks like the items in the outer list are lofted together, instead of lofting the corresponding index numbers from each list.

Permalink Reply by George Faber on May 15, 2012 at 8:54am

No need, the graft component did the job

Permalink Reply by Michael Pryor on May 15, 2012 at 10:13am

also note, you dont need graft, flatten, reverse, or simplify components in a lot of cases, you can just right click an out or input and set it to graft, or flatten, ect.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service