Grasshopper

algorithmic modeling for Rhino

lofting issue

Hi guys,

 

I am trying to create a parametric podium tower through lofting a series of closed polylines, but for some reason the it won't loft the off-setted part of the tower. This is probably a dump question, what have i done wrong?

 

Also using graph mapper to control the offset distance is nice and convenient but not the best solution for what i want to achieve. I want the offset distance to be 10% from edge of the below level. what is the best way to go about it?
Cheers,

 

Matt

Views: 417

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on March 2, 2011 at 12:06am
please share your ghx, its easier to reply
Permalink Reply by nc on March 2, 2011 at 12:29am

Sure. added the ghx to the main post.

Permalink Reply by Dedackelzucht on March 2, 2011 at 12:49am
the offset output was your problem
Attachments:
Permalink Reply by nc on March 2, 2011 at 1:26am

Hi Dackel,

 

I am running .6 grasshopper so i have problem opening your definition. Any chance that you can point out how might resolve the issue? 

 

Appreciate you help mate!

 

Cheers,

 

Matt

Permalink Reply by Dedackelzucht on March 2, 2011 at 1:28am
Permalink Reply by Dedackelzucht on March 2, 2011 at 1:29am
Permalink Reply by nc on March 2, 2011 at 1:52am

Oh I see, all i had to do was to flatten it, thanks for help!

Permalink Reply by Dedackelzucht on March 2, 2011 at 3:15am
hihi...indeed my answer could be much easier, i am still a little bit tired :-)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service