lofting between curves

Is anyone able to help me figure out how I loft between these two curves? I've tried flattening them and a few tutorials online but not getting very far - I'm trying to create a thin ribbon effect. any help would be greatly appreciated.

Attachments:

4.gh, 39 KB

Replies to This Discussion

Permalink Reply by Vicente Soler on October 26, 2013 at 2:47pm

Try the ruled surface component.

Permalink Reply by Tash Tash on October 27, 2013 at 7:33am

Hi Vincente - many thanks for your reply. I couldn't get that to work, but is a new and interesting component to me, many thanks. In the end I realised I had to flatten & graft it.

Attachments:

help.jpg, 441 KB

Permalink Reply by Vicente Soler on October 27, 2013 at 10:10am

You just have to connect the first set of curves to the A input and the second set of curves to the B input, very simple, no need to change the data structure.

Permalink Reply by David Merlin on October 27, 2013 at 9:10am

This is a data matching issue. There are two sets of three curves, so corresponding curves need to be on their own branch for the loft. This can be accomplished using graft.