lofting

Replies to This Discussion

Permalink Reply by Dedackelzucht on January 5, 2011 at 12:25am

Can you post the file? Or make some screenshots

Permalink Reply by Takumi Yoshioka on January 5, 2011 at 2:33am

Yes, please take look at these. 

Thanks!

Permalink Reply by Dedackelzucht on January 5, 2011 at 2:48am

mh...can you post the ghx/3dm? I guess the offset curves are the problem. Put a rebuildcurve into the file.

Permalink Reply by Takumi Yoshioka on January 5, 2011 at 2:58am

yap! thanks a lot!

 

Attachments:

• voronoi curv lofting.3dm, 66 KB
• voronoi curv lofting .ghx, 157 KB

Permalink Reply by Takumi Yoshioka on January 5, 2011 at 3:08am

Thanks for your suggestion, but a rebuild-curve component didn't work neither. uhnnn, just wondering why....

Permalink Reply by Dedackelzucht on January 5, 2011 at 3:08am

Your  offset is not clean. Make only the voronoi and the frist offset visible than you see a mistake on the left side

Permalink Reply by Takumi Yoshioka on January 5, 2011 at 3:09am

oh, thank you! I'll try!

Permalink Reply by Dedackelzucht on January 5, 2011 at 3:20am

Got it :-)

 

1. In rhino: set xyz coordinates of your points and the plane on the same Z coordinate -> Your Offset in the voronoi works

 

2. in Grasshopper: loft your map curves without flatten

 

 

Permalink Reply by Takumi Yoshioka on January 5, 2011 at 4:07am

It worked with one object, but messed up with multiple objects. I gave the u v evaluation point on Rhino, still messing up....uhnnnnnn

Permalink Reply by Dedackelzucht on January 5, 2011 at 4:54am

Isn´t that what you are looking for?

Attachments:

• voronoicurvlofting2.3dm, 61 KB
• voronoicurvlofting2.ghx, 138 KB