Grasshopper

algorithmic modeling for Rhino

Loft won't accept curve as valid input

I'm trying to loft a set of curves, 3 ellipses and a fourth curve which was generated by projecting an ellipse onto a cylinder.

The loft will accept the three ellipses as valid curves, but will not take the projected curve as a valid one.

Anyone would help me on this ?

 

Views: 1764

Attachments:

Replies to This Discussion

Permalink Reply by Matt Gaydon on December 24, 2010 at 7:35am

Hi Charles

 

Its because the projected crv is in a different tree to the other 3 Crvs. Just Flatten the S input on the Loft Component that the crvs connect to and it will work fine.

 

Merry Christmas

Matt 

Permalink Reply by Charles C Vincent on December 24, 2010 at 8:05am

Wow, just that simple !
Thanks and Merry Xmas !

 

Charles 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service