Grasshopper

algorithmic modeling for Rhino

Hi Guys!

Please help. How can I loft these curves together? ( blue line) and then make the round cup on the top (black line)? 

Thanks a lot!

Views: 314

Replies to This Discussion

Loft is the wrong tool for this job - it only works with sequential sections (connect A to B, B to C, C to D, etc). Try patch instead - it will try to fit a surface through all your 3d curves. you may need to draw a few additional curves to get the geometric result you're looking for.

Thanks Andrew! I was thinking, that loft is not a good idea . I tried patch and is much better. I need to just optimize some curves.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service