Grasshopper

algorithmic modeling for Rhino

Loft simple curves (lines) to generate surfaces

Hi All,

I have generated a number of lines, with the aim of translating them say 25 units in the x.

With two lists and lofting between the lists to generate 7 surfaces from the lists, can someone please tell me what am I missing?

Just when I thought it was safe to get back in the water.

regards

Kenyon

Views: 496

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 2, 2017 at 10:17am

Hi.

The biggest mistake is that if you provide all the curves into the loft, then all 14 curves would be lofted continuously. Check attached.(Red group)

Attachments:
Permalink Reply by Kenyon Graham on February 2, 2017 at 12:05pm

Awesome took me a little time to determine what to do with the loft to get at the surfaces...open up the loft with a flatten.

Thanks

Kenyon

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service