Grasshopper

algorithmic modeling for Rhino

loft problem

hello everyone!

i am trying to loft between two rectangles as shown in the attached image. i have also uploaded the .gh file for reference. any help would be appreciated. i am basically trying to attempt the chair family mentioned in beta's discussion at http://www.grasshopper3d.com/forum/topics/help-7?commentId=2985220%...

thanks in advance!

Views: 628

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on September 2, 2013 at 7:01am

Permalink Reply by Umar Jamshaid on September 2, 2013 at 7:27am

Thanks Mario!

Can you please share the logic behind this and tell me where i was wrong?

and could you please share the definition as well?

Thanks once again!

Permalink Reply by Umar Jamshaid on September 2, 2013 at 7:29am

No need for definition, the image would do it.

Thanks man!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service