Grasshopper

algorithmic modeling for Rhino

loft problem

Hi Everyone,

I'd like to make a loft surface from Grasshopper curves, I mean curves made in Grasshopper not in Rhino. Is this possible?
I tried it several times but it seems that I can not plug in more than one curve for sections?

Dan

Views: 904

Replies to This Discussion

Permalink Reply by Vittorio Menna on September 19, 2009 at 7:28am
keep shift pressed when u plug in all your curves... and be aware u plug them in the right order...
Permalink Reply by Daniel Kulinyi on September 19, 2009 at 2:08pm
Thanks a lot! It works!
Permalink Reply by Vittorio Menna on September 19, 2009 at 8:58pm
u r welcome!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service