Grasshopper

algorithmic modeling for Rhino

Loft of 2 voronoi elements.

I would like to do some kind of a loft, using 2 voronoi. The top part with the bottom part.

-BOTH are made with the same points. 
-The bottom part is made from an offset of the top part. 

I would like to LOFT each bottom surface with its respective top surface. 

Here is a example made with photoshop :-P
I would like to develop a parameter for this...I'm lost.

Views: 1263

Replies to This Discussion

Permalink Reply by patric guenther on August 3, 2014 at 9:51am

just loft both edge curves of each cell

Permalink Reply by Kalil Sarraff on August 3, 2014 at 10:47am

Hi Patrick, i tried to do it, but at the end is a total mess...
Maybe I have to use a flatten or graft component? I will try. 

Permalink Reply by Kalil Sarraff on August 3, 2014 at 10:48am

I will try to take each surface, with an item list. It's an slow process, but it will work. Thanks!

Permalink Reply by Andrew Kudless on August 5, 2014 at 11:16pm

Here is a quick file. You just need to put each cell's inner and outer curve on to the same branch (n=2) and then loft.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service