Grasshopper

algorithmic modeling for Rhino

loft error

Is anyone able to tell me why lofting these curves in grasshopper fails? There are no duplicate lines - but the error message says it doesn't know why the loft failed, so I'm a bit stumped. Many thanks for any help!

Views: 411

Attachments:

Replies to This Discussion

Permalink Reply by lucas cañada on March 14, 2014 at 7:37pm

Hi again Tash! I can tell you but i can´t explain...Your first and your last curves are flipped. But i dont know why loft components returns that message instead of create the geometry. See you ;))

Permalink Reply by Tash Tash on March 14, 2014 at 8:11pm

brilliant!! thanks again lucas!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service