Grasshopper

algorithmic modeling for Rhino

Loft error

Hi Guys, I've a problem: I did an OFFSET, then a LOFT , but this is the result:

There is a curve (boundary) and the result of the offset (inner curve). I've 3 floor plans, but this is the only with this problem.

Views: 447

Replies to This Discussion

Permalink Reply by Jonathan Sandoval on April 4, 2013 at 12:02pm

What about join > offset > planarSrf  than you can extrude x amount for your wall heights

Best,

Jon

Permalink Reply by Jonathan Sandoval on April 4, 2013 at 12:08pm

Permalink Reply by Landscape on April 4, 2013 at 1:07pm

Yeah, it works better, thank U Jonathan.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service