Loft Component Problems.

I was working through the following tutorial: http://designalyze.com/tutorial/fun-graph-mapper

but have been having some issues when it comes time to add the Loft Component. Instead of being able to include both sets of curves from the IntCrv boxes, I am only able to add one. As soon as I connect the second, the initial input disconnects.

I'm sure there is an option someplace I am missing, or a basic procedure I am violating, but I have no idea what it could be. I've worked through the tutorial a few times, but end up with the same result. I do have the most updated version of Grasshopper, but a subsequent version running on Rhino 4 displayed the same behavior, and also lacks the Array functions required in later steps.

I have attached my work thus far,

Any help would be greatly appreciated.

Attachments:

vase.gh, 22 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Matt Gaydon on August 21, 2015 at 5:02pm

Hi MattDC

Hold down Shift key when you drag the second wire across to connect it to the Loft Component. Its should come up with a Plus sign on a little green arrow when it does this let go of the mouse then the Shift key and it should have connected.

Added Bonus

If you Hold Down Ctrl key and select a wire you can disconnect it from the input/output.

Hold Down Ctrl and Shift keys and you can disconnect All wires and reconnect them into another input/output on the same component or another component

Hope these are some help.

Permalink Reply by MattDC on August 21, 2015 at 5:42pm