Loft changing color

Hi,

I am trying to make my lofts (originally gray) change color depending on a distance factor, the problem is that once the loop (with a hoopsnake component) has passed that point, the loft goes back to gray. I was wondering if anyone could help me figure out how to make the lofts stay the color they were assigned even after the hoopsnake has finished.

Thank you so much! :)

Attachments:

5.41 13 Sept Con Loop Funcionando.gh, 29 KB
Centrito Valle.3dm, 60 KB

Replies to This Discussion

Permalink Reply by Michael Pryor on September 13, 2012 at 8:06pm

Are you just trying to color things based on distance?

Permalink Reply by babym on September 13, 2012 at 8:12pm

Yes,

based on a conditional statement, if the distance is less than 20, then it turns one color, if its greater then another

Permalink Reply by Michael Pryor on September 13, 2012 at 8:23pm

and looking at your def its not obvious but distance of what from what? You don't need hoopsnake for this.

Permalink Reply by babym on September 13, 2012 at 8:35pm

Let me try to explain what I'm trying to do..

The lofts are selected at random through a random component and those are the ones that need to be measured. The distance that I need to compare is the distance between one of the lofts and the one closest to it , if the distance is greater than 20, then it should be green, if it is smaller, then it should turn pink.

I used the hoopsnake because I needed it to cover all of the lofts, and I couldn't find another way to do it... but I'm relatively new to grasshopper and I'm open for suggestions :)

Im not sure if I'm being clear..? And thanks so much for all your help

RSS