Grasshopper

algorithmic modeling for Rhino

Loft between two meshes ?

Hello!
I have no idea if it is possible to loft between two meshes (like if they were two surfaces). My Problem is that I have two meshes that I would like to Close somehow, maybe the word "loft" is not describing my purpose so well but.. here it is:


I start with a flat surface (build with the red Points on the Picture)

Then, I subdivide this surface to extract the Vertices that will build my new mesh (The green Points) The Transformation of the Points comes from a Point Charge (I use fields)

The result ist something like this (see the last Picture):


So I Need help :( I cant figure it out whats the best way to achieve the Mesh that I want... I dont know how can I start from my flat mesh and generate the second one and then Close it. I dont Need the flat mesh, just as a reference from where i want my final mesh to start from...
Hope someone can understand this mess hehe and give me some tips about building the correct mesh..
Thank you!!

Views: 2658

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 11, 2016 at 10:11am

Hi.

Something like this? Check attached.

You'll need "Meshedit" plug-in. Best.

Attachments:
Permalink Reply by Natalia De Leon on October 12, 2016 at 2:43am

Oh yes... exactly what I wanted to see,. You teached me a bit more about the Mesh Component hehe
Thank you so much !

Permalink Reply by Jaeyoon Jeong on February 13, 2018 at 1:51pm

In my case, I found that the mesh between two ones is skewed. So I add some curve seam adjusting process to your code. 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service