Grasshopper

algorithmic modeling for Rhino

loft a series of curves with its offset

Hello there,
I have this funny problem:

-I have a series of curves
-I have a series of curves that are offset from the previous curves
-now I want to loft each first curve only with its related offset, but how?
check the image: the target is to loft the green lines -first set of curves- with the red line -the offset-

 thanks for help.

Views: 1766

Attachments:

Replies to This Discussion

Permalink Reply by Shawn Fernandez on December 3, 2010 at 8:50am
The problem is that your data structures don't match. See the attached file, The Panel and Param viewer will show you the structure of your data. Start with the tutorials as they give an introduction to Data Trees and then do a search on the discussions here for "Data Tree." It will take some practice, but Data Trees are not as bad as we first make them out to be.
Attachments:
Permalink Reply by paul piciorul on December 3, 2010 at 9:23am
ops! yes, i forgot it.
thanks for your help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service