Grasshopper

algorithmic modeling for Rhino

Locating Naked Edges on Brep

I have a recurring issue within my workflow that results in naked edges being produced at intersection points of created edge fillets. Fixing the problem is straightforward enough in Rhino, but it is time consuming and a very manual process.

I'm new to GH, and lack a lot of the "chops" of knowing which components to use, and when to properly use them for issues related to Rhino workflow.

What I think I am trying to accomplish is as follows:

1. Using an input geometry (brep) select all naked edges

2. Having all naked edges selected, create branches of data items (naked edges) that fall within a certain geometrically-defined spatial region (sphere with radius)

Then end result being multiple branches of data, each containing the naked edges of single intersections.

To reference the attached screen shot, I'm trying to select the edges surrounding the opening in the brep, then define them as data items within a branch.

Any help would be greatly appreciated, 

Zack

Views: 3002

Attachments:

Replies to This Discussion

Permalink Reply by Zack on April 29, 2015 at 7:23am

Still struggling with this one, wondering if anyone has any ideas still?

Permalink Reply by ng5 Alex on April 29, 2015 at 7:43am

Zack please upload your definition

its difficult to suggest anything without taking a look at it.

cheers

alex

Permalink Reply by Zack on April 29, 2015 at 8:01am

Sorry, I meant it more of a general question, 

Here's an example file demonstrating the problem situation I'm trying to address via Grasshopper. The areas containing the naked edges are located at the interior intersection points of each main support section. ( see pic )

Attachments:
Permalink Reply by ng5 Alex on April 29, 2015 at 8:19am

Hello Zack

this could be a way to do it

cheers

alex

Attachments:
Permalink Reply by Zack on April 29, 2015 at 8:32am

Man, 

That's exactly it.

Thank you so much.

Permalink Reply by Thomas Yulki Takeuchi on April 29, 2015 at 8:25am

Permalink Reply by Zack on April 29, 2015 at 1:27pm

Nice, I like the simplicity of that one particularly.

Thanks a lot for your help. Seriously just saved me hours by being able to do this.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service