Grasshopper

algorithmic modeling for Rhino

Listings Bug?

Is this a problem at my end or is everyone seeing this behaviour?

When I open the Grasshopper3d,com page and the Listings Panel populates I see this:

It only flashes as "Just Now" for a fraction of a second before settling on:

and then eventually I get this as the finished product:

Where it stays like this until the next time I visit or reload the page.

Views: 274

Replies to This Discussion

Permalink Reply by Faberyayo on June 3, 2013 at 2:21am

I see dead people it too.

Permalink Reply by Danny Boyes on June 3, 2013 at 4:09am

There's good news and bad news.

Good News: The reason its happening is because the Listing has been removed.

Bad News:   The reason its happening is because the Listing has been removed.

One for Scott I think

Permalink Reply by David Stasiuk on June 3, 2013 at 4:51am

Yep, this is happening for me, and I'm the one who both listed and removed it...:)

Permalink Reply by phillip on June 3, 2013 at 6:26am

I was hoping you would not remove, but only close it. Now we are back to the Listings without proper content. So Danny is right by pointing out, the flashing is the most exciting about it.

Permalink Reply by David Stasiuk on June 3, 2013 at 6:38am

Is there an option to only close it?  I don't remember seeing it, but that doesn't mean it isn't there.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service