Grasshopper

algorithmic modeling for Rhino

List. Please Help

Hello,
 I am trying to connect 2 facing
divided surfaces with straight lines. For some reason these lines cross
each other, instead of just having straight perpendicular lines. I
believe the order of the points in one of the surfaces is different.

I have tried to sort and shift it, but  no success.


 Any help or advice would be great

 

Thanks in advance

 



Views: 177

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on September 13, 2010 at 3:31am
Hi Antonio,

seems one of your surfaces has the U (or is it V?) direction reversed. If you're importing these surfaces from Rhino, try using the _Dir command to flip it. Otherwise you may have to use Grasshopper List Reverse component to adjust the output.

--
David Rutten
david@mcneel.com
Poprad, Slovakia
Permalink Reply by Antonio Monserrat on September 13, 2010 at 8:07am
It worked! only had to reverse U, and use a reverse List, like you suggested.

Thanks a lot

A

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service