Grasshopper

algorithmic modeling for Rhino

list organization

I have 54 lines, they need to be broken up into sets of 3.  I think this requires path mapper but I have no idea how to use it.

Views: 231

Replies to This Discussion

Permalink Reply by Danny Boyes on May 25, 2010 at 4:57pm
Hi liam have a look at this thread talking about the modulo operator http://www.grasshopper3d.com/forum/topics/simplify-this?commentId=2...
Permalink Reply by Liam Morrow on May 25, 2010 at 5:02pm
thanks

you don't happen to know how to rotate a trimmed surface because it dosen't seem to be working.
Permalink Reply by Liam Morrow on May 25, 2010 at 6:08pm
nevermind figure it out.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service