link height=angle

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on October 29, 2017 at 6:12am

Are you after that ? I put a panel with 10 but the best is to link the number of steps in the range component to the number in U in the "surface from points" component.

I don't understand were is the angle ? A good sketch is worth 1000 words !

Permalink Reply by manvj on October 29, 2017 at 6:36am

hi, thank you for your answer. you're right, here is a little sketch.

the surface is under my spikes and the more the spikes are high, the more the surface should inflect.

Attachments:

• IMG_5277.jpg, 786 KB

Permalink Reply by Hyungsoo Kim on October 29, 2017 at 12:15pm

Hi.

Take a look at the attachment.

Attachments:

• SurfaceBulging+Extrusion_re.gh, 18 KB

Permalink Reply by manvj on October 29, 2017 at 1:36pm

thank you it's amazing !!!!

However you used Rebuild surface I think it calls like that, just after point deform. I don't have it. is it a pluging ? if yes which one ? thank you very much it is a great work :)

Permalink Reply by Hyungsoo Kim on October 29, 2017 at 1:38pm

Lunchbox

Permalink Reply by manvj on October 29, 2017 at 1:56pm

thank you very much.

I am going to try to adapt it to my file to be able to have more control on heights and the grid.

Permalink Reply by manvj on October 30, 2017 at 9:56am

Do you know how don't have de square edge fix ?

here a drawing

Attachments:

• image1.JPG, 32 KB

Permalink Reply by Hyungsoo Kim on October 30, 2017 at 10:27am

If you have analyzed the details of the definition enough, you can easily identify the part related to Edge Fixing.(I even wrote explanations as group titles)

This is not a definition that has a lot of contents is it?

Anyway, check this out.

Attachments:

• SurfaceBulging+Extrusion_reV2.gh, 20 KB

Permalink Reply by manvj on October 30, 2017 at 11:17am

Thank you