lines normal to a curve

Replies to This Discussion

Permalink Reply by Damien Alomar on September 18, 2009 at 7:46am

Create curve frames (not horizontal of vertical planes), decompose the plane, create an Start/Direction/Length Line with the origin of the plane as the start and the Y vector as the direction

Permalink Reply by roberto gagliano on September 18, 2009 at 8:39am

thanks a lot , damien.
i made a small change, because i need all the lines point to the same direction of the curve, so i used a perp frame component instead.
the rest is perfect.
still, i thought this would be easier. maybe a component, called line perp, constrained to a plane (which i was missing)

cheers roberto

Permalink Reply by Theunis du Toit on September 18, 2009 at 9:02am

There are two other ways. I think the easiest one for me is the "Curvature" component. It points the lines to one side so no conditional statements are needed. Also very handy is the centre points it gives, making a line between the curvature points and the original points on your curve and making those lines proprtionally as long as the factor of curvature at the originating point.

Permalink Reply by Gennifer E Munoz on September 18, 2009 at 9:07am

great! thank you.

Permalink Reply by roberto gagliano on September 18, 2009 at 9:19am

i always need this on closed planar curves.
is there an easy way to make the lines point outwards?

Permalink Reply by Theunis du Toit on September 18, 2009 at 9:38am

Where relavent make the direction negative. For example for the "SDL line" component right click on input "D" (where the vector comes in) and in expresion write "-(d)" and it will reverse the lines.

Permalink Reply by Dedackelzucht on October 6, 2011 at 6:13am

http://www.grasshopper3d.com/forum/topics/vectors-problem

do you mean this?

Permalink Reply by Dedackelzucht on October 6, 2011 at 9:05am

and how about evalute the crv at the randomly shattered startingpoints and use the t as input for horizontal planes? or am I mssunderstanding something here?

Permalink Reply by Gennifer E Munoz on September 18, 2009 at 8:15am

if you are attempting to create lines oriented the same direction, you will need to include a conditional statement that deals with the inflection point of the curve. (seen in damien's image.) this should test, for your specific curve, where the vectors are changing direction.