Line needed as perpendicular to plane at centroid point

Replies to This Discussion

Permalink Reply by lucas cañada on December 23, 2011 at 1:25am

maybe there is another solution. Let us know. Hope helps.

Attachments:

• lineneeded.3dm, 53 KB
• lineneeded.gh, 3 KB

Permalink Reply by lucas cañada on December 23, 2011 at 1:55am

if you unitize vector you can get the real length

Attachments:

• lineneeded.gh, 3 KB

Permalink Reply by Naveen on December 23, 2011 at 4:16am

Thanks it worked for me, but seems like i am generating lines in opposite directions too, hereby enclosed, pls help

Permalink Reply by lucas cañada on December 23, 2011 at 4:33am

Post your deff

Permalink Reply by Naveen on December 23, 2011 at 4:38am

Here's how I am trying to crack,pls help

Attachments:

• Getting Lenghts.3dm, 956 KB
• Space Frame.gh, 15 KB

Permalink Reply by lucas cañada on December 23, 2011 at 5:05am

sorry it happens me too. ;(

Permalink Reply by lucas cañada on December 23, 2011 at 5:21am

problem is in referenced curves,how you created before bake, bacause here are only baked lines and some of them are flipped 

Permalink Reply by Naveen on December 23, 2011 at 5:38am

Agreed, Actually I did create uv division (rectangular pattern on surface) and suddenly I was told that the rectangle modulation would be changed to rhombus matrix. So I did draw manually - triangular lines within rectangular patterns. Any best way to break the rectangular pattern into triangles(to form like a rhombus), pls help

Enclosed is the models from which triangles where built

Attachments:

• 1600 Module Model.3dm, 951 KB
• 1600 Module Code.gh, 56 KB

Permalink Reply by lucas cañada on December 28, 2011 at 4:32pm

Hi naveen sorry for delay but _Christmas...

Try this deff. Hope helps. Regards.

Attachments:

• lineneeded_3.3dm, 335 KB
• lineneeded_2.gh, 15 KB

Permalink Reply by Naveen on January 31, 2012 at 9:55pm

Hi Lucas,

Apologies its been a month I am responding to your message, due to christmas and chinese new year holiday's. Thanks for the inputs i'll go through and get back to you,

Cheers!
Naveen

Permalink Reply by Naveen on February 1, 2012 at 10:33pm

Hi,

Thanks for the code, works fine :)