Grasshopper

algorithmic modeling for Rhino

Line Direction towards a point

Hi, 

New to grasshopper :( is it possible to have a direction towards a point instead of XYZ? 

Im trying to draw some lines towards the middle of a circle from the circle but I can only specify direction XYZ? meaning all the lines will only go from the circle to the left or right etc. but I want it all to go towards the centre of the circle... how can i do it? 

Thanks! 

Views: 1178

Replies to This Discussion

Permalink Reply by Filippos Filippidis on September 15, 2016 at 6:17am

Hi JM,

Check attached

Best

F

Attachments:
Permalink Reply by JM on September 15, 2016 at 6:26am

THANKYOU SO MUCH! It worked perfectly on mine! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service