Grasshopper

algorithmic modeling for Rhino

Line connection

Hi! My attempt to create the wall panel has ended with deadlock. Actually i think that to do that i should us SHIFT or something like as. But just to think isn`t enough I attached the file rhino and grasshopper. If there are some body who can help me please respond. Thanks and sorry for english

Views: 331

Attachments:

Replies to This Discussion

Permalink Reply by Hassan David Jassir on November 12, 2010 at 12:24pm
Actually, in "Curves - Analysis" you can find the "End Points" component, it shows the start and end points of curves. Hope it helps you.
Permalink Reply by Andrew SAlov on November 12, 2010 at 2:31pm
mmm. that did not help. I need something like that(attached pic) it will be grat if vertices number will go from 0 - n I mean one by one but not from 0 to 3 then I could clean list by Cull pattern(I hope ^_^) So // any ideas?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service