Grasshopper

algorithmic modeling for Rhino

Line apearing when baking plain surface.

Hi, I have a strange problem.
When bake the generated surface, some vertical and horizontal lines,
are added to the draw.
I don not how to remove the lines by hand in Rhino, so store like DXF
and re open.
Then it must to be removed by hand.

Which may be the cause of the problem

In red is the grashopper generated surface.
In black is the same surface baked.



Rhinov Version: 5 SR5
Grasshopper 0.9.0076

Views: 692

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on November 26, 2016 at 5:25pm

It's just the isocurves that Rhino draws on surfaces. You can change the settings on a per object basis in the Rhino Object Properties panel (Isocurve Density section).

Permalink Reply by Marcelo Arguello on November 26, 2016 at 5:34pm

Thanks,

I would never have found it without your help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service