limiter

Hi All,
i have a problem limiting a value to a certain amount and if that amount is exceeded the limit-amount will be used instead. does anyone know how to handle that?

Attachments:

limiter.ghx, 51 KB

Replies to This Discussion

Permalink Reply by Damien Alomar on October 5, 2009 at 8:23am

You should check out the Function List that's available within the function components (go to the expression designer). In this case you probably want to use the Min function, where one of the inputted values is the largest that you want to use, and the other value is the output of the division you're doing.

Permalink Reply by Philipp Dittus on October 5, 2009 at 8:33am

Thanks Damien,
but when i limit it to a maximum value, then i'd probably need the max funcion, right?
so then i write as a funcion "Max (x,y)"? but when i enter that, then all i get is a red component...

Permalink Reply by Philipp Dittus on October 5, 2009 at 8:47am

ok i got it, thanks a lot!

RSS