Lattice Structure

Replies to This Discussion

Permalink Reply by Tim Chen on August 10, 2017 at 9:37am

It may make things a bit easier if you post the GH file? :)

Permalink Reply by said on August 10, 2017 at 1:02pm

Hello Tim, Thanks for your reply my GH file is very simple , compilation of what i found on net

Attachments:

• 161004_Question02000.gh, 33 KB

Permalink Reply by Hyungsoo Kim on August 10, 2017 at 2:07pm

Check attachment. Best.

Attachments:

• 161004_Question02000_re.gh, 45 KB

Permalink Reply by said on August 11, 2017 at 12:49am

Thank you so much Kim,

yes it is mutching my need, in the picture attached I would like to add inner brace for each X section, and suppress top and bottom horizontals for each X section not included the top section - See attached picture

Thanks again for your Support

Attachments:

• Grasshopper_Sample3.png, 135 KB

Permalink Reply by Hyungsoo Kim on August 11, 2017 at 1:08am

You could easily add what you want  if you understood this definition in detail.

Attachments:

• 161004_Question02000_reV2.gh, 18 KB

Permalink Reply by said on August 11, 2017 at 1:21am

Thanks Kim,

how can I remove the horizontal as Shown  in the attached picture ?

Attachments:

• Grasshopper_Sample3.png, 135 KB

Permalink Reply by Hyungsoo Kim on August 11, 2017 at 2:49am

...

Attachments:

• 161004_Question02000_reV3.gh, 19 KB

Permalink Reply by said on August 11, 2017 at 3:09am

Thank you Kim for your Support ,

This is perfect now I will now try to separate upper horizontal to affect different profile cross section

Regards

Permalink Reply by said on August 12, 2017 at 9:09am

Dears,

I dont know if you can support me again about the problem i matches about extension of legs as per below picture.

I tried to split the legs to get a shoues at base and some extended lenght on top as shown there but I could not , can you get a look on ?

thanks in advance

Attachments:

• screenshot_504.png, 38 KB

Permalink Reply by Hyungsoo Kim on August 12, 2017 at 9:55am

Try to use "Extend Curve".

Permalink Reply by said on August 12, 2017 at 10:19am

Thanks Kim for your support

I could extend top side , but i want to split legs as per picture below , Diagonals must stay on same position as they are now- Thanks in advance

Permalink Reply by Hyungsoo Kim on August 12, 2017 at 11:35am

It seems to be better to actually restart from scratch because your persistent change request has made it clear that the existing definition will be messed up.

The important thing is whether you understand this definition in detail.

Attachments:

• 161004_Question02000_reV4.gh, 21 KB

• ‹ Previous
• 1
• 2
• Next ›
• Page