Grasshopper

algorithmic modeling for Rhino

Keeping an angle within a certain range

Hey. First time on here and I thought I would start with a question :)

I am doing a Parametric Tent. So far I have it set up that I have the basic tent shape set up that can be expanded on the x, y and z axis. However obviously when it is extruded on x the angle of the pitch reduces until it would become unviable.

I am wondering if anyone knows how to set it so that we can attach a range to the tent so that the pitch will not reduce lower than say 25 degrees.

Would be greatful for any help!

Jason

Views: 268

Replies to This Discussion

Permalink Reply by Manuel on December 15, 2009 at 7:24pm
Hi, it is a little difficult without an image or definition.. but maybe the min or max component can help you.
Permalink Reply by Jason on December 16, 2009 at 2:35am
Hey. Thanks for your reply. Have attached an image of what im trying to do to see if it helps.


The green bit should say this is where the angle is that im trying to keep between a range

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service