Grasshopper

algorithmic modeling for Rhino

kangaroo vault from grid

hi again,

i'm trying to make a vault by hanging this grid pattern. it started as circles so i made then lines. they dont seem to hang as cleanly if i do the same thing with just a hex grid.  any input would be appreciated.

thanks so much

Views: 922

Attachments:

Replies to This Discussion

Permalink Reply by cait on May 4, 2015 at 8:04pm

Hi alessandro,  here is the newer file and explanation:

if i just use a simple hex grid i can get  kangaroo to work and i get the pattern to sag the grid (when restrained to it's corners) but if i use my network it spazes out. 

thank you thank you

Attachments:
Permalink Reply by Alessandro Liuti on May 4, 2015 at 8:27pm

Hi,

kangaroo works with distcretised elements - thus you need to approximate your circles into segments. Here a possible solution for the customised grid; i hope that's what you were looking for.

Cheers.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service