Kangaroo freezing simulation

Replies to This Discussion

Permalink Reply by Nik Willmore on August 16, 2015 at 8:05am

A specific example would help.

There are also Kangaroo versus Kangaroo2 which have different behavior.

Kangaroo normally needs a timer but you can also make it run a fixed number of iterations by feeding the Kangaroo Sequence/Frames component into the Kangaroo Reset input, though I've only ever used this for its MeshMachine utility.

Ah, your script is shown here:

http://www.grasshopper3d.com/forum/topics/kangaro-and-galapagos-opt...

I'm only on iPhone right now, so it'll have to wait.

Since your are using a timer, I recall just right clicking to stop the timer by disabling it, then the output remains.

Permalink Reply by Nik Willmore on August 16, 2015 at 2:27pm

Here I see Kangaroo being used with little remote control interface I hadn't been aware of:

http://www.grasshopper3d.com/group/kangaroo/forum/topics/new-origam...

Permalink Reply by Nik Willmore on August 16, 2015 at 6:27pm

INITMSTINM = "it's not in the manual since there is no manual":

You just double click the Kangaroo1 component to bring up the old school tape recorder control! I had no idea.

Kangaroo2 has no such secret Easter egg, alas.

Permalink Reply by Lorenzo Mirante on August 23, 2015 at 6:39am

Hey Nik, thanks very much for your help.
I have tried with the kangaroo bar (obtained with the double clicking ad you suggested me) but it seems it is not able to completely freeze the simulation, it slows down the simulations but not totally.
Anyway I will try now with Kangaroo Sequence/Frames!
Thanks