Grasshopper

algorithmic modeling for Rhino

Kangaroo - Curve Pull (Jambox surface)

Hello everyone!

 

I'm new to grasshopper and I'm having some troubles trying to create a surface similar to the jambox one...

 

 

I've been using the Kangaroo Curve Pull, but I don't know how to adjust the springs and the pull strenght properly, but I'm pretty sure that's a way of doing it...

 

Anyway, I'm uploading my files so you guys can take a look and I'm also accepting suggestions! :)

 

Thank you very much!

Views: 1766

Attachments:

Replies to This Discussion

Permalink Reply by Bruno Boas on April 26, 2013 at 12:12pm

Nobody can help me?

:/

Permalink Reply by Arie-Willem de Jongh on October 14, 2016 at 5:14pm

Here ya go, more then 3 years to late, I'm not that fast =)

I hope it helps,

Cheers!

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service