Grasshopper

algorithmic modeling for Rhino

Kangaroo anchor points

Hi,

I've been trying to make a bending simulation using Kangaroo, after Andre Johansen's post on gridshells. For the second part, where the anchor points are supposed to be the points of intersection between the grid and a Brep under O level, Kangaroo doesn't recognize those intersection points, just the contour points of the grid. Why? How can all the anchor points be recognized?

Views: 1414

Attachments:

Replies to This Discussion

Permalink Reply by Daniel Piker on July 2, 2015 at 5:30am
Hi Cornelia,

You need to split the lines at these points, so that they become the new spring end points.
Permalink Reply by Cornelia Costin on July 2, 2015 at 5:32am

ok. I'll try. Thank you.

Permalink Reply by Cornelia Costin on July 2, 2015 at 6:52am

I split the lines, and it works if I use the C component. 

Another question: What should the lines for the Kangaroo/geometry input be?

If I put only the lines that I put in the springs component into the geometry  input in kangaroo component, the grid falls apart.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service